1. Insert the EZClaim CD.
2. If the setup program does not run automatically, click on the ‘Start’ button and select ‘Run’.
3. Type in ‘d:setup’ (d: being your CD-ROM drive letter).
4. Press ‘Enter’ or click on the OK button.
5. Follow the on-screen directions (basically keep clicking the ‘Next’ button).
Note: If you are upgrading to a new version, do not uninstall your current version, simply install the software with the new CD. Your data will remain but the program will be updated. We suggest backing up your data before installing new versions. See Backing Up and Restoring Patient Data for more information on backing up your data.
1. Double Click on the ‘EZClaim Icon’ on your Desktop (If an EZClaim icon was not automatically installed on your desktop, see Creating an Icon on your Desktop). Or, if you do not have an EZClaim icon on your desktop, click on the ‘Start’ menu button and select Programs and then EZClaim.
2. Click the ‘Next’ button to move to the Provider Information screen. On this screen, enter data in all fields you want to be automatically filled each time you add a new patient. If you do not want data to be pre-filled or will fill it in later, leave this page blank.
3. Click the ‘Next’ button to move to the Registration screen.
IMPORTANT: If you do not register at this time, the program will run for 30 days without registering. If your trial period expires, you WILL NOT lose your data. Simply register the software to gain full access.
Trial Users:
To continue using the program in Trial mode, click the ‘Finish’ button to complete the program setup.
Registered Users:
Enter your registration number and key code into the fields then click ‘Finish’. The program will show a registration confirmation box showing the program has been registered.
Normally, the setup program will create an icon labeled EZClaim Program on your desktop. If, for some reason the icon is not created, use the following steps to make one.
1. Go to the Start menu>Programs>EZClaim
2. From the Dropdown menu right click on EZClaim Program
3. Select “Send To”
4. Click on “Desktop (create shortcut)”